Step 1- Identify Connector on Bottom of Tablet
Step 2 – Download and Extract Tools & Firmware
Extract the downloaded .rar files to your computer
Step 3 – Configuring the Flashing Software
Run IUW1.2.exe from the location where you extracted the InfoTMIC Burning Tool file. I have highlighted the areas of interest
Select the following files from the location you extracted the 2.3
Firmware. Replace the % with either 5 or 30, depending on your model as
determined in Step 1.
U0 = \uboot\u-boot-nand.bin
Kernal = \Image\Gmac-%P\
android\uImage
System = \Image\Gmac-%P\android\system.img
User = \Image\Gmac-%P\android\userdata.img
Ramdisk = \Image\Gmac-%P\android\ramdisk.img
Step 4 – Put Your Tablet into OTG mode
Press and hold the M button on the side of the tablet and press the power button.
The device will stay on the infoTMIC screen.
Connect the tablet to your computer using the usb cable
.If you are prompted to install a driver, it is contained in the otg_driver folder in the location where you extracted InfoTMIC Burning Tool rar file. This is a windows 32 bit driver, so you may experience difficulties if you have a 64bit system
.
Step 5 – Flash the Tablet
If the device is connected ok, the Dv. Section at the bottom of the screen will go green and the tablet will say Communicating with PC....
Double check your settings and ensure you have the device plugged into the mains and then click Burn.
Various messages will appear on the tablet
screen and in the status window of the IUW software. DO NOT DISCONNECT
USB OR TURN OFF DEVICE UNTIL IT FINISHES, OTHERWISE YOU COULD BRICK
YOUR DEVICE.
Step 6 – Reboot Tablet
Upon completion, your tablet will tell you to “Please pull out OTG line and restart”.
Use a paper clip or something similar to press the reset button on the side of the tablet.
happy programming to all
bro.bon_bon
